Users Guide

Related
Commands
show ip bgp ipv6 unicast dampened-paths — views BGP dampened routes.
debug ip bgp ipv6 unicast soft-reconfiguration
Enable soft-reconfiguration debugging for IPv6 unicast routes.
Syntax
debug ip bgp [ipv4-address | ipv6-address | peer-group-name] ipv6
unicast soft-reconfiguration
To disable debugging, use the no debug ip bgp [ipv4-address | ipv6-
address | peer-group-name] ipv6 unicast soft-reconfiguration
command.
Parameters
ipv4-address |
ipv6-address
Enter the IP address of the neighbor on which you want to
enable soft-reconfiguration debugging.
peer-group-name Enter the name of the peer group on which you want to enable
soft-reconfiguration debugging.
ipv6 unicast Debug soft reconfiguration for IPv6 unicast routes.
Defaults Disabled.
Command Modes EXEC Privilege
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.2(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
Usage Information
This command turns on BGP soft-reconfiguration inbound debugging for IPv6 unicast
routes. If no neighbor is specified, debug is turned on for all neighbors.
Related
Commands
show ip bgp ipv6 unicast dampened-paths — views BGP dampened routes.
debug ip bgp keepalives
Allows you to view information about BGP keepalive messages.
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name]
keepalives [in | out]
IPv6 Border Gateway Protocol (IPv6 BGP) 822