Users Guide

Supported Modes Full—Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.4(0.0) Introduced on the MXL 10/40GbE Switch IO Module.
8.4.2.1 Introduced on the C-Series and S-Series.
8.4.2.0 Introduced on the E-Series TeraScale.
7.5.1.0 Introduced on the E-Series ExaScale.
redirect
Configure a rule for the redirect list.
Syntax
redirect {ip-address | slot/port} | tunnel tunnel-id}[track <obj-
id>]{ip-protocol-number | protocol-type [bit]} {source mask | any
| host ip-address} {destination mask | any | host ip-address}
[operator]
To remove this filter, use one of the following:
• Use the no seq sequence-number command if you know the filter’s sequence
number.
• You can also use the no redirect {ip-address | slot/port}| tunnel
tunnel-id}[track <obj-id>]{ip-protocol-number [bit] |
protocol-type} {source mask | any | host ip-address}
{destination mask | any | host ip-address} [operator] command.
Parameters
ip-address Enter the IP address of the forwarding router.
slot/port Enter the keyword slot / port followed by the slot/port
information.
ip-protocol-
number
Enter a number from 0 to 255 for the protocol identified in the
IP protocol header.
tunnel Enter the keyword tunnel to configure the tunnel setting.
tunnel-id Enter the keyword tunnel-id to redirect the traffic.
track Enter the keyword track to enable the tracking.
track <obj-id> Enter the keyword track <obj-id> to track object-id.
protocol-type Enter one of the following keywords as the protocol type:
• icmp for internet control message protocol
• ip for any internet protocol
Policy-based Routing (PBR) 1182