Reference Guide

Command Modes
• CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.6.(0.0) Supported on the FN I/O Aggregator.
8.3.17.0 Supported on the M I/O Aggregator.
Usage Information This command is supported on the M I/O, FN410S, and FN410T Aggregators.
Example
Dell(conf)#stack-unit 0 iom-mode stack
% You are about to stack your IOA module, please reload the IOA
and then plug in the stacking cable for the changes to take effect.
Dell(conf)#
Dell#
Related Commands
reload— Reboots the operating system.
show system— displays the current status of all stack members or a specic member.
stack-unit priority
Congure the ability of a switch to become the management unit of a stack.
Syntax
stack-unit stack-number priority 1-14
Parameters
stack-number Enter the stack member unit identier.
1–14 This preference parameter allows you to specify the management priority of one
backup switch over another, with 0 the lowest priority and 14 the highest. The
switch with the highest priority value is chosen to become the management unit if
the active management unit fails or on the next reload.
Defaults 0
Command Modes CONFIGURATION
Supported Modes All Modes
Command History
Version Description
9.6.(0.0) Supported on the FN I/O Aggregator.
9.3(0.0) Supported on the M I/O Aggregator.
Usage Information This command is supported on the M I/O, FN410S, and FN410T Aggregators.
Related Commands
• reload – reboots Dell Networking Operating System (OS).
• show system – displays the status of all stack members or a specic member.
300