Installation Manual

12
NOTE: Ensure that the back GPGPU card riser is secured to the sled cover using
the type B screw holes.
7 Align the right air baffle with the screw holes on the back of the sled cover.
8 Secure the right air baffle to the sled cover using the two M3 screws. Tighten the screws to
5.21 in-lb.
Figure 1-12. Installing the Right Air Baffle
9 Align the front mounting bracket with the screw holes on the left of the GPGPU card and
secure with two M2.5 screws. Tighten the screws to 5.21 in-lb.
10 Align the back mounting bracket with the screw holes on the right of the GPGPU card and
secure with two M3 screws. Tighten the screws to 5.21 in-lb.
Figure 1-13. Installing the Mounting Brackets
1 M3 screws (2) 2 right air baffle
1 M2.5 screws (4) 2 front mounting bracket
3 Tesla K10 GPGPU card 4 M3 screws (2)
5 back mounting bracket