Owners Manual
Related links
Safety instructions
Installing the optional LSI 2008 SAS mezzanine card
Installing the 1GbE mezzanine card
Installing the 10GbE mezzanine card
Installing a system board
Installing the system board assembly
System memory
System memory holds the instructions that the processor executes. Each system board has sixteen DDR4 memory module sockets for the
installation of up to sixteen registered DDR4-2400 MHz (2400 MHz at 2 memory modules per channel) memory modules to support
processor 1 and processor 2. For the location of the memory modules, see the C6320 system board connectors section.
Related links
C6320 system board connectors
Memory slot features
• Support 8 channels, 16 DDR4 registered DIMMs (RDIMMs)
• Speed up to 2400 MT/s
• Maximum capacities: 512 GB with 32 GB RDIMM
• Supports DDR4
• Supports Error Correction Code (ECC)
NOTE
: Linux operating system does not support the S4 (hibernation) mode.
Supported memory module conguration
For the sequence of the 16 memory-module sockets, the system requires at least one memory module installed on processor 1’s DIMM slot
1 in order to boot up. When you insert the memory modules, always start with CHA_A1. The optimized memory module installation
sequence is 1, 2, 3, 4, 5, 6, 7, and 8.
Figure 57. DIMM slot locations
104
Installing and removing system components