Owners Manual

Figure 35. Installing the 2.5-inch drive cage cover

Next steps

1. Install the drive cage into the PSU 2 bay.

2. Follow the procedure listed in After working inside your system.

Removing 2.5-inch cabled drives from the drive cage

Prerequisites

NOTE:

To identify the drive, see the label on the drive cable. For more information, see Drive Specifications in the

PowerEdge C4140 Technical Specs at .www.dell.com/poweredgemanuals.

1. Follow the safety guidelines listed in the Safety instructions section.

2. Follow the procedure listed in Before working inside your system.

3. Keep the Phillips #2 screwdriver ready.

4. Remove the 2.5-inch drive cage.

5. Remove the 2.5-inch drive cage cover.

Steps

1. Remove the screws securing the drive to the drive cage.

NOTE:

If the 2.5-inch drive has Torx screw, use Torx 6 screwdriver to remove the screws securing the drive to the

drive cage.

2. Remove drives 0 and 1 by performing the following steps:

a. Disconnect the signal and power cable from the drives.

b. Lift drive 0 out of the drive cage.

c. Slide drive 1 out of the drive cage.

PowerEdge C4140 installing and removing system components