Release Notes

50 System Firmware Version 5.1.1.7
Summary
User Impact
Resolution
Affected
Platforms
SysUpTime is not being shown
correctly during an SNMP walk
(Poll interval 1sec)
Potential operator confusion regarding
switch operation.
The correct variable is used
to write SysUpTime
All
Platforms
Log messages need to be
corrected on ip dhcp snooping
rate limit scenario.
Potential operator confusion regarding
switch configuration. Inability to diagnose
network issues.
Interface representations in
log messages use unit-slot-
port format.
All
Platforms
The show ip vlan command
output is not proper after more-
quit prompt is encountered, i.e.
after around 16 routing
interfaces
Potential operator confusion regarding
switch configuration.
The paging has been
corrected.
All
Platforms
Invalid error port number
displayed on log message when
vlan is changed to forbidden
mode from access mode
Potential operator confusion regarding
switch configuration.
The error message is no
longer issued.
All
Platforms
The banner motd XXXXX
does not appear in show
running-config
Potential operator confusion regarding
switch configuration.
All banner configuration
appear in the running-config
PCM8024
Web page mac-vlan table too
slow to load.
Potential operator frustration with switch
management.
For certain browsers, paging
has been implemented to
speed up load times.
All
Platforms
Confused between ip default
gateway and ip default route
(update manual with how to set
a default route).
Potential operator confusion regarding
switch configuration.
The ip default route
command is deprecated. Use
the ip default route
command to set a default
route.
All
Platforms
Auto Install show boot retry
count line needs to be left
aligned by one space.
None. The retry count alignment is
corrected
All
Platforms
Cannot Access Optical
Transceiver Diagnostics Page if
Multiple Submits done prior to
initial refresh completing
Potential operator frustration with switch
management.
This is a browser dependent
issue (IE 6) that is not seen
in later versions. The web
session recovers after doing
a refresh.
All
Platforms
Error messages for non-existent
stack members non-informative
Potential operator confusion regarding
switch configuration.
The user can pre-configure
stack units. If the stack unit
does not exist for a switch
configuration operation, an
error message indicating
same is issued.
PC70XX
Traffic is forwarding when
IPv6 forwarding is disabled
Incorrect operational state in network. The ipv6 forwarding
command is deprecated. To
disable traffic forwarding, use
the “no ipv6 unicast-routing”
in place of the “no ipv6
forwarding” command.
PCM8024
A LAG member comes UP if
configured individually as no
shutdown, even though the
port-channel's state is down
Incorrect operational state in network. LAG members are placed in
the blocking state for
dynamic LAGs and only
come up when the LAG link
comes up.
All
Platforms