Release Notes

34 System Firmware Version 5.1.1.7
Release 4.2.1.3
"ip http secure-
server"
command not
getting migrated
from 4.1.0.19
build to 4.2.1.3
build.
ip http secure-server command not getting
applied when we migrate from 4.1.0.19 to
4.2.1.3 release
Corrected command parsing
problem.
All 4.2 supported
platforms
Data loop in
Simple mode
when adding
VLAN
A data loop occurs in the port-aggregator if
a new VLAN is added to an interface.
Corrected the VLAN creation
error.
PCM6220
PCM6348
PCM8024
PCM8024-k
Summary
User Impact
Resolution
Affected Platforms
The “show fiber
optical-
transceiver"
command shows
LOS even
though link is
up.
The “show fiber optical-transceiver"
command was reporting incorrect values
when optical transceivers that did not
support diagnostics were used.
Correct diagnostics so that
diagnostics for unsupported
transceivers are not displayed.
All 4.2 supported
platforms
Unable to ping
with jumbo
frames set
MTU size configured on the combo ports
will be lost after a save and reload and also
when changes the media preferences are
made.
Corrected the storing of the
MTU size
PC72xx and PC80xx
platforms
cpCaptivePortal
WebLangCode.
1.1 displays en
when mib says
only supported
value active (1)
The description of the
cpCaptivePortalConfigWebLangCode
object doesn't correspond to the values it
returns.
Corrected the description in
the fastpath_captive_portal.mx
file
All 4.2 supported
platforms
LLDP
Assignment of
port ID for Port-
Description
TLV
When Port-Description is set as no
description in LLDP port configuration, the
TLV should contain the Port Interface name
as the port description by default instead of
0.
Corrected the default Port-
Description.
All 4.2 supported
platforms
The CLI shows
incorrect media
type 10GBASE-
T for fiber ports
The "show interface advanced firmware"
shows incorrect information under "Type"
column.
Removed the Type column
which was not valid.
All 4.2 supported
platforms
Can't assign a
name to a
VLAN
Config migration for the "name <vlan
name>" command was not correct.
Corrected the config migration
for the "name <vlan name>"
command.
All 4.2 supported
platforms
No default route
or static
showing in ip
route table
"Show ip route" commands will not display
route even though there were routes is in the
router(static routes, ospf routes) for
terminal length 0.
Corrected the display of the
"Show ip route" command.
All 4.2 supported
platforms
CLI command
"show dot1x
users" is missing
CLI command "show dot1x users" is
missing
Corrected the command tree
for the "show dot1x users"
command.
All 4.2 supported
platforms