Reference Guide

970 ARP Commands
Default Configuration
This command has no default configuration.
Command Mode
User EXEC and Privileged EXEC modes, Config mode and all Config sub-
modes
User Guidelines
The show arp command will display static (user-configured) ARP entries
regardless of whether they are reachable over an interface or not.
Example
The following example shows show arp command output.
console#show arp
Static ARP entries are only active
when the IP address is reachable on a local subnet
Age Time (seconds)............................. 1200
Response Time (seconds)........................ 1
Retries........................................ 4
Cache Size..................................... 6144
Dynamic Renew Mode............................ Disable
Total Entry Count Current / Peak.............. 0 / 0
Static Entry Count Configured / Active / Max .. 1 / 0 / 128
IP Address MAC Address Interface Type Age
---------- -------------- --------- ------ -------
1.1.1.3 0000.0000.0022 n/a Static n/a
2CSPC4.XModular-SWUM204.book Page 970 Friday, March 15, 2013 9:24 AM