Reference Guide

RADIUS Commands 731
Default Configuration
The default priority is 0.
Command Mode
Radius mode
User Guidelines
User must enter the mode corresponding to a specific Radius server before
executing this command.
Example
The following example specifies a priority of 10 for the designated server.
console(config)#radius-server host 192.143.120.123
console(config-radius)#priority 10
radius-server attribute 4
Use the radius-server attribute 4 command in Global Configuration mode to
set the network access server (NAS) IP address for the RADIUS server. The
NAS IP address is RADIUS attribute number 4. Use the no version of the
command to set the value to the default.
Syntax
radius-server attribute 4 ip-address
no radius-server attribute 4
• ip-address — Specifies the IP address to be used as the RADIUS attribute
4, the NAS IP address.
Default Configuration
If a RADIUS server has been configured on the switch, the default attribute 4
value is the RADIUS server IP address.
Command Mode
Global Configuration mode
2CSPC4.XModular-SWUM204.book Page 731 Friday, March 15, 2013 9:24 AM