Reference Guide

IPv6 MLD Snooping Querier Commands 541
ipv6 mld snooping querier query-interval
Use the ipv6 mld snooping querier query-interval command to set the MLD
Querier Query Interval time. It is the amount of time in seconds that the
switch waits before sending another general query. Use the "no" form of this
command to reset the Query Interval to the default.
Syntax
ipv6 mld snooping querier query-interval interval
ipv6 mld snooping querier query-interval
• interval — Amount of time that the switch waits before sending another
general query. (Range: 1–1800 seconds)
Default Configuration
The default query interval is 60 seconds.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command
Example
console(config)#ipv6 mld snooping querier 120
ipv6 mld snooping querier timer expiry
Use the ipv6 mld snooping querier timer expiry command to set the MLD
Querier timer expiration period. It is the time period that the switch remains
in Non-Querier mode once it has discovered that there is another Multicast
Querier in the network. Use the "no" form of this command to reset the timer
expiration period to the default.
Syntax
ipv6 mld snooping querier timer expiry timer
2CSPC4.XModular-SWUM204.book Page 541 Friday, March 15, 2013 9:24 AM