Reference Guide

System Management Commands 1705
Syntax
hardware profile portmode {1x40g|4x10g}
no hardware profile portmode
Parameter Description
Default Configuration
By default, 40G ports are configured in 1x40G mode.
Command Mode
Interface Config mode
User Guidelines
This command can only be executed on the 40G interface. Entering this
command on any of the 4x10G interfaces (or any other 10G port) will give an
error.
This command takes effect only after rebooting the switch.
hostname
Use the hostname command in Global Configuration mode to specify or
modify the switch host name. To restore the default host name, use the no
form of the command.
Syntax
hostname name
no hostname
Parameter Description
1x40g Configure the port as a single 40G port using 4 lanes.
4x10g Configure the port as four 10G ports, each on a separate lane.
This mode requires the use of a suitable 4x10G to 1x40g pigtail
cable.
2CSPC4.XModular-SWUM204.book Page 1705 Friday, March 15, 2013 9:24 AM