Reference Guide

1458 Captive Portal Commands
Default Configuration
There are no users configured by default.
Command Mode
Captive Portal Configuration mode.
User Guidelines
There are no user guidelines for this command.
Example
console(Config-CP)#user 1 password
Enter password (8 to 64 characters): ********
Re-enter password: ********
user session-timeout
Use the user session-timeout command to set the session timeout value for a
captive portal user. Use the “no” form of this command to reset the session
timeout to the default.
Syntax
user user-id session-timeout timeout
no user user-id session-timeout
• user-id —User ID (Range: 1–128).
•
timeout —Session timeout. 0 indicates use global configuration (Range:
0–86400 seconds).
Default Configuration
The global session timeout is used by default.
Command Mode
Captive Portal Configuration mode.
2CSPC4.XModular-SWUM204.book Page 1458 Friday, March 15, 2013 9:24 AM