Reference Guide

Routing Information Protocol Commands 1381
ip rip
Use the ip rip command in Interface Configuration mode to enable RIP on a
router interface. Use the no form of the command to disable RIP on the
interface.
Syntax
ip rip
no ip rip
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
console(config-if-vlan2)#ip rip
console(config-if-vlan2)#no ip rip
ip rip authentication
Use the ip rip authentication command in Interface Configuration Mode to
set the RIP Version 2 Authentication Type and Key for the specified VLAN.
Use the no form of the command to return the authentication to the default
value.
Syntax
ip rip authentication {none | {simple key } | {encrypt key key-id }}
no ip rip authentication
• none—Do not use RIP authentication on the VLAN.
2CSPC4.XModular-SWUM204.book Page 1381 Friday, March 15, 2013 9:24 AM