Reference Guide

OSPF Commands 1221
Example
The following example configures the metric value and type for the default
route advertised into the NSSA.
console(config-router)#area 20 nssa default-info-
originate 250 non-comparable
area nssa no-redistribute
Use the area nssa no-redistribute command in Router OSPF Configuration
mode to configure the NSSA Area Border router (ABR) so that learned
external routes are not redistributed to the NSSA.
Syntax
area area-id nssa no-redistribute
no area
area-id nssa no-redistribute
• area-id — Identifies the OSPF NSSA to configure. (Range: IP address or
decimal from 0–4294967295)
Default Configuration
This command has no default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the NSSA ABR.
console(config-router)#area 20 nssa no-redistribute
2CSPC4.XModular-SWUM204.book Page 1221 Friday, March 15, 2013 9:24 AM