Owner's Manual

Managing General System Settings 285
add interface interface
intf-list
Add member Ethernet ports to the Aggregator Group.
• interface –Specify the Ethernet interface type, for
example GigabitEthernet or TenGigabitEthernet.
•
intf-list — List of Ethernet interfaces to add. Separate
nonconsecutive ports with a comma and no spaces. Use a
hyphen to designate a range of ports.
duplex {half | full} Configure the full/half duplex operation of all member
ports in the aggregator group/zone.
mtu disable Set the MTU size to default (1518) on all the member
ports in the aggregator group/zone.
negotiation Enable auto-negotiation of all member ports in the
aggregator group/zone.
speed {10 | 100} Configure the speed of all member ports in the aggregator
group/zone.
lacp {auto | static | off} Configure the LACP mode of the group to dynamic
(auto), static, or none (off).
minimum active uplinks
{1-4}
Set the minimum number of uplinks to be active for the
aggregator group.
CTRL + Z Exit to Privileged EXEC mode.
show port-aggregator
group summary
View summary information about the Port Aggregator
groups.
show port-aggregator
port summary
View summary information about the Port Aggregator
group member ports.
show port-aggregator
port-channel summary
View summary information about the LAG configuration
for all groups.
show port-aggregator
vlan summary
View summary information about the VLAN configuration
for all groups.
show mac address-table
port-aggregator group
{1–8}
View the MAC address table entries for the specified Port
Aggregator group.
Command Purpose