Quick Reference Guide
Radius Commands 305
User Guidelines
• There are no user guidelines for this command.
Example
The following example configures the source IPv6 address used for communication with RADIUS
servers.
radius-server timeout
The radius-server timeout Global Configuration mode command sets the interval for which a device
waits for a server host to reply. Use the no form of this command to restore the default.
Syntax
•
radius-server timeout
timeout
• no radius-server timeout
•
timeout
— Specifies the timeout value in seconds. (Range: 1 - 30)
Default Configuration
The default value is 3 seconds.
Command Mode
Global Configuration mode.
User Guidelines
• There are no user guidelines for this command.
Example
The following example sets the interval for which a device waits for a server host to reply to 5 seconds.
Console (config)# radius-server source-ipv6 3156::98
Console (config)# radius-server timeout 5
5400_CLI.book Page 305 Wednesday, December 17, 2008 4:33 PM