Owner's Manual

18 Installing Oracle 11g R1 Database RAC
Before You Begin
Before you begin the upgrade process, complete the following steps:
1
On the first node, log in as root.
2 Shut down Oracle Clusterware by entering the following in the terminal
window and pressing
<Enter> :
crsctl stop crs
3
On the remaining nodes, open a terminal window and repeat step 1
and step 2.
4 On the first node, log in as oracle .
5 In the terminal window, type the following and press <Enter> :
export ORACLE_HOME=/crs/oracle/product/11.1.0/crs
Installing 11.1.0.7 Patch Set for Oracle Clusterware
NOTE: You must install the patch set software from the node where the RAC 11g R1
software was installed.
1 Start the Oracle Universal Installer by entering the following in the
terminal window and press
<Enter> :
cd /opt/oracle/patches/Disk1/
./runInstaller
2
The Welcome screen is displayed. Click Next .
3 In the Specify Home Details screen, click Next .
4 In the Specify Hardware Cluster Installation Mode screen, click Next .
5 In the Summary screen, click Install .
The Oracle Universal Installer scans your system, displays all the patches
that are required to be installed, and installs them on your system.
When the installation completes, the
End of Installation screen
is displayed.
NOTE: This procedure may take several minutes to complete.
6 Read all the instructions in the message window that is displayed.
NOTE: Do not shut down the Oracle Clusterware daemons, as you already
performed this procedure in step 1 and step 2.
7 Open a terminal window.