Owners Manual

Steps

1. Align the notch on the solid-state drive with the tab on the solid-state drive connector on the system board.

2. Insert the solid-state drive at a 45-degree angle into the solid-state drive connector.

3. Replace the screw (M2x3.5) that secures the M.2 2230 PCIe solid-state drive to the system board.

Next steps

1. Install the hard-drive assembly.

2. Install the front bezel.

3. Install the side cover.

4. Follow the procedure in after working inside your computer.

Removing the M.2 2280 PCIe solid-state drive

Prerequisites

1. Follow the procedure in before working inside your computer.

2. Remove the side cover.

3. Remove the front bezel.

4. Remove the hard-drive assembly.

About this task

The following images indicate the location of the solid-state drive and provide a visual representation of the removal procedure.

Lahtivõtmine ja kokkupanek