Owners Manual

Steps

1. Remove the two screws (M2x4) that secure the wireless-card shield to the system board.

2. Unroute the antenna cables from the routing guides on the display-assembly base.

3. Lift the wireless-card shield out of the system.

4. Remove the screw (M2x4) that secures the wireless-card bracket to the wireless card.

5. Slide and remove the wireless-card bracket off the wireless card.

6. Disconnect the antenna cables from the wireless card.

7. Slide and remove the wireless card from the wireless-card slot.

Installing the wireless card

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

NOTE: To avoid damage to the wireless card, route the antenna cables accurately.

About this task

The following image indicates the location of the wireless card and provides a visual representation of the installation procedure.

Removing and installing components