Reference Guide

Category System Health (DIAG = Diagnostic)
Severity Severity 1 (Critical)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔
CMC
DIAG0620
Message Network arg1 - arg2
Arguments arg1 = Number, arg2 = Failure Message
Detailed
Description
UEFI Driver provides a DIAGNOSTIC protocol and this protocol supplies a test that
failed. Failure Message may be "Packet loopback test failed" or "Register test failed"
or something else. Provided by driver not ePSA.
Recommended
Response
Action
The Network (Ethernet) device may be faulty. Check for bent pins in the Ethernet
connector. Make sure that Network device firmware is current. Retry test, if still
fails, replace the NIC/NDC/LOM Network device. This may be on the motherboard,
or an adapter, or a daughter card, depending on the system.
Category System Health (DIAG = Diagnostic)
Severity Severity 1 (Critical)
Filter
Visibility
IPMI
Alert
SNMP
Alert
Email
Alert
Remote System
Log
WS
Eventing
iDRAC ✔
CMC
LC Log LCD OS Log Power
Off
Power
Cycle
Reset Chassis Event
Proxy
iDRAC ✔
CMC
DIAG0621
Message Network arg1 - Driver version arg2 outdated. Version arg3 or newer required for "
arg4 "
444