Reference Guide

Omconfig Global Rescan Controller
Description Rescans all the controllers on the system. For more information about Global Rescan
Controller, see the Dell OpenManage Online Help .
Syntax
omconfig storage globalinfo action=globalrescan
Example to Do a global rescan of all controllers. The omconfig command syntax for rescanning all
controllers on the system does not require a controller or enclosure ID.
NOTE: Global rescan is not supported on non-RAID SCSI and SAS controllers. Reboot
the system to make visible the configuration changes on non-RAID SCSI controllers.
Example
omconfig storage globalinfo action=globalrescan
Omconfig Set Hot Spare Protection Policy
Table 115. Omconfig Set Hot Spare Protection Policy
Description Sets the hot spare protection policy for dedicated or global hot spares. For more
information, see the Dell OpenManage Server Administrator Storage Management User’s
Guide at dell.com/support/manuals.
Syntax
omconfig storage globalinfo action= setprotectionpolicies
type=dhs raid=<r1 | r5 | r6 | r10 | r50 | r60 | all>
hscount=<1-16> warnlevel=<0-3> includeghsinvdstate=<yes |
no>, where hscount is the number of hot spares assigned to the virtual disk and
warnlevel is the severity level you want to assign to the generated alert, if this policy is
violated. Use hscount=0 warnlevel=0 to reset the dedicated hot spare protection
policy for the RAID level.
Example for Global hot spare protection policy
Example
omconfig storage globalinfo action=setprotectionpolicies
type=dhs hscount=1 warnlevel=1 includeghsinvdstate=yes
Omconfig Connector Commands
The following table displays the omconfig command syntax required to execute connector tasks.
Table 116. omconfig Connector Commands
Required Command
Levels (1, 2, 3)
Optional name=value pairs
omconfig storage
connector
action=rescan controller=id connector=id
Omconfig Rescan Connector
Description Rescans a controller connector. This command rescans all connectors on the controller
and is therefore similar to performing a controller rescan.
NOTE: This command is not supported on SAS controllers.
Syntax
omconfig storage connector action=rescan controller=id
connector=id, where id is the controller ID and the connector ID as reported by the
176