Users Guide
1. Launch the Create Virtual Disk Advanced Wizard by doing the following:
a. Locate the controller on which you are creating a channel-redundant virtual disk Expand the controller object until the Virtual Disks object is
displayed.
b. Select the Virtual Disks object and click Go To Create Virtual Disk Wizard.
c. Click Virtual Disk Advanced Wizard.
2. Complete "Create Virtual Disk Advanced Wizard (Step 1 of 4)." This portion of the Create Virtual Disk Advanced Wizard asks you to select a RAID level.
When creating a channel-redundant virtual disk, it is recommended that you select the following RAID levels.
Recommended RAID Levels:
¡ PERC 3/DC, 3/QC, 4/DC, 4e/DC, 4/Di, and 4e/Di Controllers: It is recommended that you only use RAID 10 or RAID 50.
¡ PERC 3/Di Controller: It is recommended that you only use RAID 10.
3. Complete "Create Virtual Disk Advanced Wizard (Step 2 of 4)." In this step, you select the channels and the disks to be used by the virtual disk. The
selections you make determine whether or not the virtual disk is channel-redundant.
There are specific RAID level and configuration requirements for implementing channel redundancy. You must select the same number of physical disks
on each channel that you use. See "Number of Physical Disks per Virtual Disk" for information on the number of physical disks that can be used for
different RAID levels. See "Controller-supported RAID Levels" for information on controller-specific implementations of the RAID levels.
Depending on the controller type, use one of the following procedures when completing "Create Virtual Disk Advanced Wizard (Step 2 of 4):"
¡ "Physical disk Selection for Channel-redundant Virtual Disks on PERC 3/DC, 3/QC, 4/DC, 4e/DC, 4/Di, and 4e/Di Controllers"
¡ "Physical disk Selection for Channel-redundant Virtual Disks on a PERC 3/Di Controller:"
Physical disk Selection for Channel-redundant Virtual Disks on PERC 3/DC, 3/QC, 4/DC, 4e/DC, 4/Di, and 4e/Di Controllers
The following sections describe creating a channel-redundant virtual disk using RAID 10 or RAID 50 on a PERC 3/DC, 3/QC, 4/DC, 4e/DC, 4/Di, or 4e/Di,
controller.
RAID 10
a. Select one physical disk on each of two channels. (In other words, each of the two channels will have a single disk selected.)
b. Select an additional disk on each of the two channels. You have now selected the minimum number of disks for a RAID 10.
c. Repeat "stepb" until you have the desired number of disks.
d. Click Continue.
RAID 50
a. Select one physical disk on each of three channels. (In other words, each of the three channels will have a single disk selected.)
b. Select an additional disk on each of the three channels. You have now selected the minimum number of disks for a RAID 50. Continue selecting a
disk on each channel until you have selected the desired number of disks.
c. Repeat "stepb" until you have the desired number of disks.
d. Click Continue.
Physical disk Selection for Channel-redundant Virtual Disks on a PERC 3/Di Controller:
The following section describes creating a channel-redundant virtual disk using RAID 10 on a PERC 3/Di controller.
RAID 10
a. Select one physical disk on each of two channels. (In other words, each of the two channels will have a single disk selected.)
b. Select an additional disk on each of the two channels. You have now selected the minimum number of disks for a RAID 10.
NOTE: Channel redundancy only applies to controllers that have more than one channel and that attach to an external disk enclosure.