Users Guide

Figure 5. Firmware link communication error

1. Open Microsoft Registry Editor (Regedit).

2. Navigate to the following location:

KHEY_CURRENT_USER\Software\Microsoft\Windows\CurrentVersion\Internet Settings

3. Add a DWORD value for ReceiveTimeout.

4. Set the value to 30 seconds (30000) [This value may need to be a higher value in your environment].

5. Exit Regedit.

6. Restart Internet Explorer.

NOTE: Just opening a new Internet Explorer window is not enough. Restart the Internet Explorer browser.

What generation of Dell servers does the OpenManage Integration for VMware vCenter

congure and support for SNMP traps?

OpenManage Integration for VMware vCenter supports OMSA SNMP traps on pre-12th generation servers and iDRAC traps on 12th

generation servers.

How does the OpenManage Integration for VMware vCenter support more than three vCenters

in Linked Mode?

Each virtual appliance supports a maximum of three vCenters in Linked Mode. If you have more than ten vCenters, you need a new

instance of the appliance for every ten vCenters with associated licensing.

Does OpenManage Integration for VMware vCenter support vCenter in linked mode?

Yes , OpenManage Integration for VMware vCenter supports up to 10 vCenters either in a linked mode or not in a linked mode also.

For more information on how OpenManage Integration for VMware vCenter works in linked mode, see the white paper,

OpenManage Integration for VMware vCenter: Working in Linked Mode on www.Dell.com.

What are required port settings for OMIVV?

NOTE: When deploying the OMSA agent by using the Fix non-compliant vSphere hosts link available from the

Compliance window in OMIVV, OMIVV starts the http client service and enables port 8080 on releases after ESXI 5.0 to

download the OMSA VIB and install it. After the OMSA VIB installation is complete, the service automatically stops and

the port is closed.

Use the following port settings for OMIVV: