Deployment Guide

Table 349. SYSCFG Error Codes and Messages
Error Code Message
116 There was an error getting the option.
117 The option is not available or cannot be configured through software.
118 There was an error setting the option.
119 The -n (--namefile) option can only be used with - -pci.
120 The password may only contain alphanumeric characters.
121 The BIOS passwords have been disabled via jumper.
122 The password length must be between 1 and 32.
123 This password is locked and can only be unlocked by the admin user.
124 There was an error setting the password.
125 The LCD string length must be between 1 and %s.
126 The LCD string may only contain alphanumeric characters.
127 There was an error setting the LCD string.
128 The second channel can only be set if the RAID controller is set to
RAID.
129 The set operation requires sub commands.
130 The service tag for this system is not available.
131 The system ID value is not available.
132 The system information string is not available.
133 A system error has occurred.
134 Usage error.
135 The uuid information is not present on this system
136 Version cannot be accompanied with any other option.
137 The self-identify blinker timer should be set to 0..255 second(s).
138 Encrypt key is too long.
139 Encrypt key is invalid, accepted characters are 0 to 9 or A to F.
140 Parameter has been temporarily disabled due to a dependency on other
settings.
141 The old password supplied is incorrect. The new password will not be
set. Please try again.
142 Cannot stat /etc/omreg.cfg file. Please ensure /etc/omreg.cfg file is
present and is valid for your environment. You can copy this file from
the DTK iso.
143 Getting nicselection settings failed.
144 HAPI Driver Load Error.
145 Filter action power reduction is only supported for the system power
warn/fail filters.
146 TPM/TCM Clear settings requires setup password.
147 There is currently no TPM/TCM Clear request pending.
148 Password is not required for retrieving the ’%s’ options.
149 Setup password is required for setting the ’%s’ options.
Messages And Codes 205