User's Manual

Preparing the Script Files for Deployment Using Microsoft Windows PE 63
:: PARTCFG section
set DT_OS_SIZE=4000
set DT_OS_FSTYPE=FAT32
if not "%DT_PARTN_UP%"=="ON" goto ospart
:: DELLUP section
set DT_UP_SIZE=32
set DT_UP_IMAGE=%DT_SYSTEMS%\UPIMG.BIN
:: RAIDCFG section
set DT_VD_SIZE=10480
:: default size for virtual disk
CAUTION: DT_MOUNT specifies the mount point of the Dell utility partition.
If your RAMDRIVE, hard drive, or other device already owns this designation,
mount will not override the setting and the utility partition will not be created.
Perform the following steps to edit the default partition configuration default
values, as necessary.
1
Edit the default utility partitioning variable ( DT_PARTN_UP=ON ),
if necessary. This variable sets whether you want to install the Dell utility
partition.
NOTE: Dell recommends that you install the Dell utility partition.
2 Edit the default variable value for the default hard drive ( DT_HD=0 ),
if applicable.
NOTE: Ensure that the default variable value for DT_HD is set to a valid
non-removable disk, and not to removable media such as virtual media.
3 Edit the default variable value (in MB) for the primary operating system
partition (
DT_OS_SIZE=4000 ), if applicable.