CLI Guide

To reset the mode, use the no mode {master | transit} command.
Parameters
master Enter the keyword master to set the Ring node to Master
mode.
transit Enter the keywordtransit to set the Ring node to Transit
mode.
Defaults Mode None
Command Modes CONFIGURATION (conf-frrp)
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.2.1.0 Introduced on the C-Series.
7.4.1.0 Introduced.
protocol frrp
Enter the Resilient Ring Protocol and designate a ring identification.
Syntax
protocol frrp {ring-id}
To exit the ring protocol, use the no protocol frrp {ring-id} command.
Parameters
ring-id Enter the ring identification number. The range is from 1 to
255.
662
Force10 Resilient Ring Protocol (FRRP)