CLI Guide

Usage Information
NOTE: The vrf option is available only when VRF feature is enabled.
show ip
accounting
access-lists
Field
Description
“Extended IP...” Displays the name of the IP ACL.
“seq 5...” Displays the filter. If the keywords count or byte were
configured in the filter, the number of packets or bytes the
filter processes is displayed at the end of the line.
“order 4” Displays the QoS order of priority for the ACL entry.
Example
Dell# show ip accounting access-list L3-ACL vrf vrf3
!
Standard Ingress IP access list L3-ACL on vrf3
Total cam count 3
seq 5 permit 10.1.2.0/24
seq 10 permit 20.1.2.0/24
seq 15 permit 30.1.2.0/24
Dell#
show ip access-lists
Display all of the IP ACLs configured in the system, whether or not they are applied to an interface, and
the count of matches/mismatches against each ACL entry displayed.
Syntax
show ip access-lists [access-list-name] [interface interface]
[in | out] [vrf vrf-name]
Parameters
access-list-name Enter the name of a configured MAC ACL, up to 140
characters.
interface interface Enter the keyword interface followed by the one of the
following keywords and slot/port or number information:
• For a VLAN interface, enter the keyword vlan followed
by the slot/port number.
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port
information.
• For a Port Channel interface, enter the keyword port-
channel
followed by a number.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
in | out Identify whether ACL is applied on the ingress or egress
side.
230
Access Control Lists (ACL)