CLI Guide

description Enter a description of up to 80 characters.
Defaults Not configured.
Command Modes
• CONFIGURATION-STANDARD-ACCESS-LIST
• CONFIGURATION-EXTENDED-ACCESS-LIST
• CONFIGURATION-MAC ACCESS LIST-STANDARD
• CONFIGURATION-MAC ACCESS LIST-EXTENDED
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(1.0) Introduced on the Z9100–ON.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000–ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
8.1.1.0 Introduced on the E-Series.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
6.4.1.0 Introduced on the E-Series.
Usage Information The remark command is available in each ACL mode. You can configure up to
4294967291 remarks for a given IP ACL and 65536 remarks for a given MAC ACL.
The following example shows the use of the remark command twice within
CONFIGURATION-STANDARD-ACCESS-LIST mode. The same sequence number
was used for the remark and for an associated ACL rule. The remark precedes the
rule in the running-config because it is assumed that the remark is for the rule with
the same sequence number, or the group of rules that follow the remark.
Example
Dell(config-std-nacl)# remark 10 Deny rest of the traffic
Dell(config-std-nacl)# remark 5 Permit traffic from XYZ Inc.
Dell(config-std-nacl)# show config
!
ip access-list standard test
remark 5 Permit traffic from XYZ Inc.
222
Access Control Lists (ACL)