CLI Guide

level level Enter the keyword level then a number as the severity
level. A high number indicates a low severity level and vice
versa. The range is from 0 to 7. The default is 2.
all Enter the keyword all to turn off all.
limit number-of-
buffers
Enter the keyword limit then the number of buffers to be
queued for the terminal after which new messages are
dropped. The range is from 20 to 300. The default is 20.
Defaults Disabled. If enabled without the level or number-of-buffers options specified,
level = 2 and number-of-buffers = 20 are the defaults.
Command Modes LINE
Command History
This guide is platform-specific. For command information about other platforms,
see the relevant Dell Networking OS Command Line Reference Guide.
Version Description
9.8(2.0) Introduced on the S3100 series.
9.8(0.0P5) Introduced on the S4048-ON.
9.8(0.0P2) Introduced on the S3048-ON.
9.7(0.0) Introduced on the S6000-ON.
9.2(1.0) Introduced on the Z9500.
9.0.2.0 Introduced on the S6000.
8.3.19.0 Introduced on the S4820T.
8.3.11.1 Introduced on the Z9000.
8.3.7.0 Introduced on the S4810.
7.6.1.0 Introduced on the S-Series.
7.5.1.0 Introduced on the C-Series.
E-Series legacy
command
Usage Information
When you enable logging synchronous, unsolicited messages appear between
software prompts and outputs. Only the messages with a severity at or below the
set level are sent to the console.
If the message queue limit is reached on a terminal line and messages are
discarded, a system message appears on that terminal line. Messages may continue
to appear on other terminal lines.
Related
Commands
• logging on — enables logging.
1698
Simple Network Management Protocol (SNMP) and Syslog