Setup Guide
SNMPv2-SMI::mib-2.17.7.1.4.3.1.1.1107787786 = STRING: "My VLAN"
[Dell system output]
DellEMC#show int vlan 10
Vlan 10 is down, line protocol is down
Vlan alias name is: My VLAN
Address is 00:01:e8:cc:cc:ce, Current address is 00:01:e8:cc:cc:ce
Interface index is 1107787786
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
Displaying the Ports in a VLAN
Dell EMC Networking OS identies VLAN interfaces using an interface index number that is displayed in the output of the show
interface vlan command.
Examples of Viewing VLAN Ports Using SNMP
The following example shows viewing the VLAN interface index number using SNMP.
DellEMC(conf)#do show interface vlan id 10
% Error: No such interface name.
R5(conf)#do show interface vlan 10
Vlan 10 is down, line protocol is down
Address is 00:01:e8:cc:cc:ce, Current address is 00:01:e8:cc:cc:ce
Interface index is 1107787786
Internet address is not set
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
ARP type: ARPA, ARP Timeout 04:00:00
To display the ports in a VLAN, send an snmpget request for the object dot1qStaticEgressPorts using the interface index as the instance
number, as shown for an S-Series.
The following example shows viewing VLAN ports using SNMP with no ports assigned.
> snmpget -v2c -c mycommunity 10.11.131.185 .1.3.6.1.2.1.17.7.1.4.3.1.2.1107787786
SNMPv2-SMI::mib-2.17.7.1.4.3.1.2.1107787786 = Hex-STRING:
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
The table that the Dell EMC Networking system sends in response to the snmpget request is a table that contains hexadecimal (hex)
pairs, each pair representing a group of eight ports.
• Seven hex pairs represent a stack unit. Seven pairs accommodate the greatest number of ports available — 64 ports on the device.
The last stack unit begins on the 66th bit.
The rst hex pair, 00 in the previous example, represents ports 1 to 7 in Stack Unit 1. The next pair to the right represents ports 8 to 15. To
resolve the hex pair into a representation of the individual ports, convert the hex pair to binary. Consider the rst hex pair 00, which
resolves to 0000 0000 in binary:
• Each position in the 8-character string is for one port, starting with Port 1 at the left end of the string, and ending with Port 8 at the
right end. A 0 indicates that the port is not a member of the VLAN; a 1 indicates VLAN membership.
All hex pairs are 00, indicating that no ports are assigned to VLAN 10. In the following example, Port 0/2 is added to VLAN 10 as untagged;
the rst hex pair changes from 00 to 04.
The following example shows viewing VLAN ports using SNMP with ports assigned.
[Dell EMC Networking OS system output]
R5(conf)#do show vlan id 10
Simple Network Management Protocol (SNMP)
895