Setup Guide

The following example matches the IPv6 trac with a DSCP value of 40:
DellEMC(conf)# class-map match-all test
DellEMC(conf-class-map)# match ipv6 dscp 40
The following example matches the IPv4 and IPv6 trac with a precedence value of 3:
DellEMC(conf)# class-map match-any test1
DellEMC(conf-class-map)#match ip-any precedence 3
Creating a Layer 2 Class Map
All class maps are Layer 3 by default; however, you can create a Layer 2 class map by specifying the layer2 option with the class-map
command.
A Layer 2 class map dierentiates trac according to 802.1p value and/or VLAN and/or characteristics dened in a MAC ACL..
Use Step 1 or Step 2 to start creating a Layer 2 class map.
1 Create a match-any class map.
CONFIGURATION mode
class-map match-any
2 Create a match-all class map.
CONFIGURATION mode
class-map match-all
3 Specify your match criteria.
CLASS MAP mode
[seq sequence number] match mac
After you create a class-map, Dell EMC Networking OS places you in CLASS MAP mode.
Match-any class maps allow up to ve access-lists. Match-all class-maps allow only one. You can match against only one VLAN ID.
4 Link the class-map to a queue.
POLICY MAP mode
service-queue
Determining the Order in Which ACLs are Used to Classify Trac
When you link class-maps to queues using the service-queue command, Dell EMC Networking OS matches the class-maps according
to queue priority (queue numbers closer to 0 have lower priorities).
For example, as described in the previous example, class-map cmap2 is matched against ingress packets before cmap1.
ACLs acl1 and acl2 have overlapping rules because the address range 20.1.1.0/24 is within 20.0.0.0/8. Therefore (without the keyword
order), packets within the range 20.1.1.0/24 match positive against cmap1 and are buered in queue 7, though you intended for these
packets to match positive against cmap2 and be buered in queue 4.
In cases such as these, where class-maps with overlapping ACL rules are applied to dierent queues, use the keyword order. Dell EMC
Networking OS writes to the CAM ACL rules with lower order numbers (order numbers closer to 0) before rules with higher order numbers
so that packets are matched as you intended.
• Specify the order in which you want to apply ACL rules using the keyword order.
order
718
Quality of Service (QoS)