User manual

If the AS-PATH contains both public and private AS number or contains AS
numbers of an EBGP neighbor, the private AS numbers are not removed.
If a confederation contains private AS numbers in its AS-PATH, the software
removes the private AS numbers only if they follow the confederation numbers in
the AS path.
Private AS numbers are from 64512 to 65535 (2 byte).
neighbor route-map
Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group.
S4820T
Syntax
neighbor {ip-address | peer-group-name} route-map map-name {in
| out}
To remove the route map, use the no neighbor {ip-address | peer-
group-name} route-map map-name {in | out} command.
Parameters
ip-address Enter the IP address of the neighbor in dotted decimal
format.
peer-group-
name
Enter the name of the peer group.
map-name
Enter the name of an established route map.
If the Route map is not configured, the default is deny (to
drop all routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
NOTE: This command sends routes to peers only if an
outbound policy is configured and if there is a change in
the existing outbound policy.
Defaults Not configured.
Command
Modes
ROUTER BGP
Command
History
This guide is platform-specific. For command information about other platforms,
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Border Gateway Protocol
465