User manual

into the PBR CAM region. When incoming traffic hits an entry in the CAM, the

traffic is redirected to the corresponding next-hop IP address specified in the rule.

NOTE: Apply the redirect list to physical, VLAN, or LAG interfaces only.

Commands

• show cam pbr – displays the content of the PBR CAM.

• show ip redirect-list – displays the redirect-list configuration.

ip redirect-list

Configure a redirect list and enter REDIRECT-LIST mode.

S4820T

Syntax

ip redirect-list redirect-list-name

To remove a redirect list, use the no ip redirect-list command.

Parameters

redirect-list-

name

Enter the name of a redirect list.

Defaults None

Command

Modes

CONFIGURATION

Command

History

Version Description

9.7(0.0) Introduced on the S6000-ON.

9.4(0.0) Introduced on the S4810, S4820T, S6000, and Z9000.

8.4.2.1 Introduced on the C-Series and S-Series.

8.4.2.0 Introduced on the E-Series Tera Scale.

7.7.1.0 Introduced on the E-Series ExaScale.

1382

Policy-based Routing (PBR)