User Guide

Multibit ECC errors were detected on the RAID controller. The
DIMM on the controller needs replacement. If you continue, data
corruption can occur. Press 'X' to continue or else power off
the system, replace the DIMM module, and reboot. If you have
replaced the DIMM please press 'X' to continue.
CAUTION: When removing or replacing the PERC Mini Monolithic
Controller, hold the card by its edges marked by the blue touch points. Do
not handle the card while holding the battery or the heatsink.
For more information, see figure “Removing and Installing the PERC Mini
Monolithic Controller” in Removing The PERC Controller.
CAUTION: Multi-bit ECC errors cause data corruption and data loss. In case
of MBE errors, contact Dell Technical Support.
Probable Cause: Multi-bit ECC errors occur in the memory and can corrupt cached data and discard
it.
Corrective Action: Contact Dell Technical Support.
Configured Disks Removed Or Not Accessible Error Message
Error Message:
Some configured disks have been removed from your system or are
no longer accessible. Check your cables and ensure all disks
are present. Press any key or ’C’ to continue.
Probable Cause: The message indicates that some configured disks were removed. If the disks were
not removed, they are no longer accessible. The SAS cables for your system might
be improperly connected.
Corrective Action: Check the cable connections and fix any issues. Restart the system. If there are no
cable problems, press any key or <C> to continue.
Battery Discharged Or Disconnected Error Message
Error Message:
The battery is currently discharged or disconnected. Verify the
connection and allow 30 minutes for charging. If the battery is
properly connected and it has not returned to operational state
after 30 minutes of charging then contact technical support for
additional assistance.
Probable Cause: This message may appear for controller without battery, depending on the virtual
disks’ policies.
Corrective Action:
• The controller battery is missing or currently inaccessible, contact Dell support
if the problem persist after 30 minutes.
• The controller battery is completely discharged and needs to be charged for it
to become active. You must first charge the battery and wait for a few minutes
for the system to detect it.
79