Owner's Manual

Using Dell Lifecycle Controller Integration (DLCI) 33
System Viewer Utility
You must change the iDRAC credentials of the target system before you
launch the System Viewer utility to perform the various tasks.
To change the iDRAC credentials and launch the System Viewer utility:
1
Under a collection, right-click on a Dell xx1x system and select Dell
Lifecycle Controller
 Launch System Viewer .
2 The iDRAC Authentication Information screen displays the default
credentials known to the ConfigMgr. Uncheck
Use Credentials Known to
ConfigMgr (Default)
and enter the new credentials. Ensure that you
enter the valid credentials of iDRAC.
3 Click OK to launch the System Viewer utility.
You can use the System Viewer utility to:
• View and edit the hardware configuration. For more information, see
Viewing and Editing Hardware Configuration.
• View and edit the RAID configuration. For more information, see Viewing
and Configuring RAID.
• View the current firmware inventory, compare it against a baseline, and
update the firmware. For more information, see Comparing and Updating
Firmware Inventory.
• Compare the hardware configuration profiles. For more information, see
Comparing Hardware Configuration Profile.
• Export the LC logs. For more information, see Exporting Lifecycle
Controller Logs.
• View the hardware inventory for the system. For more information, see
Viewing the Hardware Inventory for the System.
NOTE: You can only edit the hardware configuration and RAID configuration
profiles directly, and not edit the system configurations directly.
DLCI_UserGuide.book Page 33 Wednesday, February 2, 2011 10:49 AM