User guide

CHAPTER 6: USING THE RMS SOFTWARE
48
Table 5 provides a list of the parameters for the MILO high-
power curvilinear array loudspeaker when in Text View.
Displaying Loudspeaker Names
By default, loudspeakers are displayed in panels with the
names entered when loudspeaker are added. You can
instead choose to display loudspeaker device names.
To set the loudspeaker name:
1. Choose Options > Title.
2. In the Set Title Type dialog box, select one of the follow-
ing options:
■ Show Device: Displays loudspeakers with their device
names.
■ Show Title: Displays loudspeakers with the name
entered when the loudspeakers are added.
3. Click OK.
WORKING WITH LOUDSPEAKER ICONS
Selecting Loudspeakers
To select a loudspeaker, do one of the following:
■ Click anywhere on the loudspeaker icon (except on the
Mute, Solo, and Wink buttons). The selected loud-
speaker becomes outlined in yellow.
■ Draw a rectangle around the entire loudspeaker icon.
The selected loudspeaker becomes outlined in yellow.
CAUTION: When selecting loudspeakers,
make sure not to click the Mute, Solo, or Wink
buttons. This will instead activate those functions, if
enabled, and not select the loudspeaker.
Table 5: Text View Parameters for MILO Loudspeaker
Parameter Function
Amplifier Peak
Voltage (Vpk)
For each amplifier channel, the peak voltage
(0–100 V)
Amplifier Average
Voltage (Vave)
For each amplifier channel, the average volt-
age (0–100 V)
Amplifier Peak
Power (Wpk)
For each amplifier channel, the peak power
output in watts
Amplifier Limiting For each amplifier channel, the percentage of
limiting
Amplifier Tem-
perature
The upper and lower heat sink temperatures
Fan Speeds Amplifier cooling fans: primary and reserve
Input Signal
Level
Measures 0–10 V and indicates the following
conditions:
Green 0 < Signal Level < 8 V
Yellow 8 < Signal Level < 9 V
Red 9 < Signal Level < 10 V
Input Polarity +2 Pin 2 hot
(No Polarity switch for the MILO)
DC Headroom Should be over 17 V DC when the AC mains
voltage is sufficient
Communication
Status Indicator
Green Loudspeaker commissioned and
online
Red Loudspeaker not commissioned or
offline
Service Pin Displays “service pin” when the Service button
is pressed on the loudspeaker’s RMS user
panel.
Fault Indicates loudspeaker faults and abnormal
operating conditions
Mute Button Green Not muted
Red Muted
Solo Button Gray Not soloed
Yellow Soloed
Wink Gray Not winked
Green Winked
Selecting a single loudspeakers