User guide

RMS USER GUIDE

6. Remove the plastic connector on the power supply

board (next to the fan power connector).

7. Apply one drop of Loctite

to each of the four standoffs

on the RMS module and then place the module in the

bottom of the power supply chassis with the LEDs facing

out and the standoffs aligned with the four screw holes in

the bottom of the chassis.

NOTE: Make sure to hold the RMS module by

its edges. Avoid touching any of the compo-

nents on the RMS module.

8. Attach the short 9-wire gray ribbon cable from the RMS

module to the connector on the power supply board.

Make sure all pins are engaged and that the connector is

firmly seated.

9. While holding the RMS module in place, place the loud-

speaker on its side and secure the RMS module using

the four screws included with the kit.

Plastic

connector