Owners Manual

Installing system board
1 Place the USB Type-C port along with the bracket in the slot on the system board.
2 Ax the tape to secure the Type-C port bracket.
3 Flip the system board and tighten the M2.0x5.0 screws to secure the USB type-C port.
4 Align the system board with the screw holders on the computer.
5 Tighten the M2.0 x 5.0 screws to secure the system board to the computer.
6 Connect the speaker, power connector, LED board, touchpad, and USH cables to the connectors on the system board.
7 Connect the eDP cable to the connector on the system board.
8 Place the metal bracket over the eDP cable and tighten the M2.0 x 5.0 screws to secure it.
9 Remove the metal bracket from the memory module connectors of the system board that was removed.
10 Place the metal bracket over the memory module connectors and tighten the M2.0 x 3.0 screws to secure it to the computer.
NOTE
: If your computer has a WWAN card, then SIM card tray installation is a requirement.
11 Install the:
a coin cell battery
b heat sink
c WLAN card
d WWAN card
e SSD card
f memory module
g speaker
h battery
i base cover
12 Follow the procedure in After working inside your computer.
  ()
 

:      
1 

 
2 
a 
38
 

