Owners Manual

3. Connect the touchpad buttons cable to the connector on the computer and secure the latch.

4. Install the two (M2x3) screws to secure the touchpad buttons on to the computer.

5. Connect the smart card reader cable to its connector and secure the latch.

Next steps

1. Install the inner frame.

2. Install the WWAN card.

3. Install the WLAN card.

4. Install the HDD.

5. Install the solid state drive.

6. Install the battery.

7. Install the base cover.

8. Follow the procedure in After working inside your computer.

LED board

Removing the LED board

Prerequisites

1. Follow the procedure in Before working inside your computer.

2. Remove the base cover.

3. Remove the battery.

4. Remove the solid state drive.

5. Remove the HDD.

6. Remove the WLAN card.

7. Remove the WWAN card.

8. Remove the inner frame.

About this task

The figure indicates the location of the LED board and provides a visual representation of the removal procedure.

Disassembly and reassembly