Owners Manual
Table Of Contents
- Dell Latitude 5500 Service Manual
- Contents
- Working on your computer
- Technology and components
- Major components of your system
- Disassembly and reassembly
- MicroSD card
- Base cover
- Battery
- WWAN card
- WLAN card
- Coin-cell battery
- Memory modules
- DC-in port
- Hard disk drive (HDD)
- Solid state drive
- Solid state drive bracket
- Inner frame
- SmartCard reader
- Touchpad buttons
- LED board
- Speakers
- Heat sink
- System fan
- System board
- Keyboard
- Keyboard bracket
- Power button
- Display assembly
- Display bezel
- Display panel
- Camera
- Hinge caps
- Display hinges
- Display (eDP) cable
- Display back cover assembly
- Palmrest assembly
- BIOS setup
- Troubleshooting
- Handling swollen Lithium-ion batteries
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Built-in self-test (BIST)
- System diagnostic lights
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- WiFi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell
3. Remove the base cover.
4. Remove the battery.
5. Remove the speaker.
6. Remove the memory module.
7. Remove the system fan.
8. Remove the DC-in .
9. Remove the WLAN card.
10. Remove the system board.
NOTE: System board can be removed with heatsink attached.
11. Remove the coin cell battery.
Steps
1. Lift the latch and disconnect the backlit cable and the keyboard cable from the connectors on the touchpad.
2. Remove the 22 (M2x2) screws that secure the keyboard to the palmrest [1].
3.
NOTE: The touchpad FFC covers one of the screws that secure the keyboard assembly to the palmrest.
Remove the keyboard away from the computer [2].
Disassembly and reassembly
83