User's Manual
– show stack-port
– show storm-control
– show storm-control all
– show system
– show system flowcontrol
– show version
– show switch
– show arp
– show bridge address-table
– show mac address-table
– show port-aggregator vlan summary
– show port-aggregator port summary
– show switch stack-ports
– show switch stack-ports counter
– show switch stack-ports diag
– show nsf
– show switch stack-standby
– show checkpoint statistics
– Show Slot
– Show tacacs
– Show spanning-tree active
– Show spanning-tree blockedports
– Show lldp dcbx interface all
– Show lldp interface all
– Show lldp tlv-select interface all
– Show lldp remote-device all
– show classofservice dot1p-mapping
– show classofservice traffic-class-group
– show interfaces traffic-class-group
– show interfaces priority-flow-control
– show interfaces tengigabitethernet <InterfaceName> priority-flow-
control
– show interfaces counters tengigabitethernet <InterfaceName>
– show lldp tlv-select interface tengigabitethernet <InterfaceName>
– show lldp interface tengigabitethernet <InterfaceName>
– show lldp dcbx interface tengigabitethernet <Interface Name> detail
3. Capture the console output
NOTE: On SAN having many PowerConnect Ethernet switches, you may need to increase the time out value.
By default, time out value for these switches is 3 minutes (in milliseconds). This value
(
powerconnectethernet.timeout
) can be modified in the file ESC.properties located in the Lasso install
directory.
56