User's Manual

– show interface priority-flow-control
– show interface switchport
– show interface trunk
– show interface description
– show interface status
– show inventory
– show lldp neighbors
– show mac-list
– show mac-address-table
– show class-map
– show license usage
– show lacp neighbor
– show lacp port-channel
– show port-channel capacity
– show port-channel load-balance
– show port-channel usage
– show port-channel traffic
– show queuing interface
– show system internal ethpm info all
– show spanning-tree mst
– show lldp neighbors detail
– show lldp tlv-select
– show vsan
– show zone
– show flogi database
4. For CEE information, run the command show tech-support
5. Capture the console output
NOTE: On SAN having many Cisco FCoE switches, you may need to increase the time out value. By default, the
time out value for these switches is five minutes (in milliseconds). This value ( ciscofcoe.timeout ) can be
modified in the file ESC.properties located in the Lasso install directory.
Manually Collecting Data For PowerConnect, Brocade B-Series, And M8428K Devices
To collect data for PowerConnect B-Series manually:
1. Log in to Power Connect B-Series FCoE switch through SSH/Telnet
2. Run the command supportShow to display FC information.
3. To display CEE information, run the command show tech-support.
If the command fails, in the case of older switch firmware, then run the following commands:
–
show running-config
–
show startup-config
–
show system
–
show version
54