Service Manual
Table Of Contents
- OptiPlex 7090 Small Form Factor Service Manual
- Contents
- Working inside your computer
- Removing and installing components
- Software
- System setup
- Troubleshooting
- Getting help and contacting Dell
10. SATA 0 connector
11. M.2 SSD PCIe connector
12. SATA 1 connector
13. ATX system power connector
14. SATA 3 connector
15. Internal speaker cable connector
16. Coin-cell battery
17. PCIe x16 (Slot2) and PCIe x4 (Slot1)
18. Type-C connector
19. Processor socket
Removing the system board
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5/3.5-inch hard-drive caddy.
5. Remove the graphics card.
6. Remove the solid-state drive.
7. Remove the WLAN card.
8. Remove the fan assembly.
9. Remove the memory modules.
10. Remove the processor.
About this task
The following images indicate the location of the system board and provide a visual representation of the removal procedure.
56
Removing and installing components