Service Manual


4. Place the memory-module cover on the system-board shield and slide the memory-module cover into place.

5. Tighten the screw that secures the memory-module cover to the system-board shield.

6. Replace the back cover (see Replacing the Back Cover).

7. Follow the instructions from step 4 to step 5 in Replacing the Front Stand.


8. Connect your computer and all attached devices to electrical outlets, and then turn them on.

9. When the message appears stating that memory size has changed, press <F1> to continue.

10. Log on to your computer.
To verify that the memory is installed correctly, click Start ® Control Panel® System and Security® System.
Check the amount of memory (RAM) listed.
Back to Contents Page

CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may
result in damage to the computer.