Owners Manual
Table Of Contents
- Inspiron 11-3147 2-in-1 Owner's Manual
- Before Working Inside Your Computer
- After Working Inside Your Computer
- Removing the Base Cover
- Replacing the Base Cover
- Removing the Battery
- Replacing the Battery
- Removing the Memory Module
- Replacing the Memory Module
- Removing the Hard Drive
- Replacing the Hard Drive
- Removing the Coin-Cell Battery
- Replacing the Coin-Cell Battery
- Removing the Wireless Card
- Replacing the Wireless Card
- Removing the Power and Volume-Buttons Board
- Replacing the Power and Volume-Buttons Board
- Removing the Speakers
- Replacing the Speakers
- Removing the Touchpad
- Replacing the Touchpad
- Removing the Processor Fan and Heat-Sink Assembly
- Replacing the Processor Fan and Heat-Sink Assembly
- Removing the I/O Board
- Replacing the I/O Board
- Removing the System Board
- Replacing the System Board
- Removing the Power-Adapter Port
- Replacing the Power-Adapter Port
- Removing the Display Assembly
- Replacing the Display Assembly
- Removing the Palmrest and Keyboard Assembly
- Replacing the Palmrest and Keyboard Assembly
- Removing the Display Back-Cover and Antenna Assembly
- Replacing the Display Back-Cover and Antenna Assembly
- Removing the Display Hinges
- Replacing the Display Hinges
- Removing the Camera
- Replacing the Camera
- Removing the Windows-Button Board
- Replacing the Windows-Button Board
- Removing the Display Cable
- Replacing the Display Cable
- Flashing the BIOS
- Getting Help and Contacting Dell
Removing the Camera
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
Before Working Inside Your Computer. After working inside your
computer, follow the instructions in After Working Inside Your
Computer. For more safety best practices, see the Regulatory
Compliance home page at dell.com/regulatory_compliance.
Prerequisites
1 Remove the base cover.
2 Remove the battery.
3 Remove the display assembly.
4 Remove the display back-cover and antenna assembly.
Procedure
CAUTION: Place the display-panel assembly on a soft and clean
surface to avoid scratching the display.
1 Place the display-panel assembly face down on a flat surface.
2 Using a plastic scribe, pry the camera module off the display bezel.
67