Service Manual



Replacing the Display Assembly



1. Follow the instructions in Before You Begin.



2. Place the display assembly in position and replace the four screws (two on each side) that secure the display assembly to the computer base.



3. Route the display cable into the routing guide and connect the cable to the connector on the system board.



4. Connect the Mini-Card antenna cables to the connectors on the Mini- Card.



5. Turn the computer over and replace the two screws at the bottom of the computer.



6. Replace the palm rest (see Replacing the Palm Rest).



7. Replace the keyboard (see Replacing the Keyboard).



8. Replace the optical drive (see Replacing the Optical Drive).



9. Replace memory module(s) (see Replacing the Memory Module(s)).



10. Replace the base cover (see Replacing the Base Cover).



11. Replace the battery (see Replacing the Battery).



Display Bezel



Removing the Display Bezel



1. Follow the instructions in Before You Begin.



screws (4)

display cable

Mini-Card antenna cables

display assembly

CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain inside the computer. Failure to do so may

result in damage to the computer.

CAUTION: The display bezel is extremely fragile. Be careful when removing it to prevent damaging the bezel.