Owner's Manual

220 Using the Local RACADM Command Line Interface
The subcommand list includes all commands that are supported by iDRAC6.
To get help for a subcommand, enter:
racadm help <
subcommand >
The command displays the syntax and command-line options for the
subcommand.
RACADM Subcommands
Table 13-1 provides a description of each RACADM subcommand that you
can run in RACADM. For a detailed listing of RACADM subcommands
including syntax and valid entries, see "RACADM Subcommand Overview."
Table 13-1. RACADM Subcommands
Command Description
clrasrscreen Clears the last crash (ASR) screen.
clrraclog Clears the iDRAC6 log. After clearing, a single entry is made
to indicate the user and time that the log was cleared.
clrsel Clears the managed server’s System Event Log entries.
config Configures iDRAC6.
getconfig Displays the current iDRAC6 configuration properties.
getniccfg Displays the current IP configuration for the controller.
getraclog Displays the iDRAC6 log.
getractime Displays the iDRAC6 time.
getssninfo Displays information about active sessions.
getsvctag Displays service tags.
getsysinfo Displays information about iDRAC6 and the managed server,
including IP configuration, hardware model, firmware
versions, and operating system information.
gettracelog Displays the iDRAC6 trace log. If used with -i, the
command displays the number of entries in the iDRAC6
trace log.
help Lists iDRAC6 subcommands.
help <subcommand> Lists usage statement for the specified subcommand.