Users Guide

For indexed groups the object anchor must be the first object after the "[ ]" pair. The following are examples of the
current indexed groups:
[cfgUserAdmin]
cfgUserAdminIndex=11
If you type racadm getconfig -f <
myexample
>.cfg, the command builds a .cfg file for the current
iDRAC7 configuration. This configuration file can be used as an example and as a starting point for your unique . cfg
file.
Modifying the iDRAC7 IP Address
When you modify the iDRAC7 IP address in the configuration file, remove all unnecessary
<variable>
=value entries. Only
the actual variable group’s label with "[" and "]" remains, including the two
<variable>
=value entries pertaining to the IP
address change.
For example:
#
# Object Group "cfgLanNetworking"
#
[cfgLanNetworking]
cfgNicIpAddress=10.35.10.110
cfgNicGateway=10.35.10.1
This file is updated as follows:
#
# Object Group "cfgLanNetworking"
#
[cfgLanNetworking]
cfgNicIpAddress=10.35.9.143
# comment, the rest of this line is ignored
cfgNicGateway=10.35.9.1
The command racadm config -f myfile.cfg parses the file and identifies any errors by line number. A
correct file updates the proper entries. Additionally, you can use the same
getconfig command from the previous
example to confirm the update.
Use this file to download company-wide changes or to configure new systems over the network.
NOTE: "Anchor" is an internal term and do not use it in the file.
Disabling Access to Modify iDRAC7 Configuration Settings on Host
System
You can disable access to modify the iDRAC7 configuration settings through Local RACADM or iDRAC Settings utility.
However, you can view these configuration settings. To do this:
1. In iDRAC7 Web interface, go to OverviewiDRAC SettingsNetworkServices.
2. Select one or both of the following:
Disable the iDRAC Local Configuration using iDRAC Settings — Disables access to modify the configuration
settings in iDRAC Settings utility.
Disable the iDRAC Local Configuration using RACADM — Disables access to modify the configuration settings
in Local RACADM.
90