User's Manual

Configuring the iDRAC Using the Web Interface 91
Enabling or Disabling Local Configuration Access
NOTE: The default setting for local configuration access is Enabled.
Enabling Local Configuration Access
1 Click System → Remote Access → iDRAC → Network/Security .
2 Under Local Configuration , click to uncheck Disable iDRAC local USER
Configuration Updates
to enable access.
3 Click Apply .
4 Click the appropriate button to continue.
Disabling Local Configuration Access
1 Click System → Remote Access → iDRAC → Network/Security .
2 Under Local Configuration , click to check Disable iDRAC local USER
Configuration Updates
to disable access.
3 Click Apply .
4 Click the appropriate button to continue.
Configuring Serial Over LAN
1 Click System → Remote Access → iDRAC → Network/Security .
2 Click Serial Over LAN to open the Serial Over LAN Configuration page.
Table 5-28 provides information about the
Serial Over LAN
Configuration
page settings.
3 Click Apply .
4 Configure the advanced settings, if required. Otherwise, click the
appropriate button to continue (see Table 5-29).
To configure the advanced settings, perform the following steps:
a Click Advanced Settings .
b On the Serial Over LAN Configuration Advanced Settings page,
configure the advanced settings as required (see Table 5-30).
c Click Apply .
d Click the appropriate button to continue (see Table 5-31).